Whilst Kahn wheels are themselves are extremely robust, the high quality and fine finishing on Kahn wheels requires careful treatment to maintain the finish and surface detailing. As such Kahn alloy wheels should be treated with the same care as vehicle paintwork.

Kahn lightweight alloy wheels represent a substantial investment and are subject to some of the harshest treatments of any vehicle component. As such it is important that the following care instructions are observed to ensure that your wheels continue to provide enjoyment throughout their life.

Before you use your wheels, give them several coats of good quality car polish/wheel wax back and front. This will help prevent the road salt, brake dust and dirt 'keying' to the surface on first use.

For cleaning after use:
Always wait for the wheels and brakes to cool down fully before cleaning after use.

Hose off any loose abrasive material with cold water before washing the wheels down. Wheels should be washed with a mildly soapy solution in warm water. The use of chemical cleaners or solutions for cleaning wheels should not be used as these can be extremely acidic or alkaline and can have an abrasive effect on the finish of the wheels.

After the wheels have been washed down thoroughly with the soap solution, rinse with cold water to remove any residual soap.

Dry the wheels and reapply wheel wax or car polish to provide a protective layer against grit, salt and tar.

In cleaning Kahn wheels always avoid using electric buffers or wire wool pads to remove tar, brake dust etc. Also avoid use of automatic car washes which can use strong acid or alkaline solutions in the water, and whose rollers can have an abrasive effect on the finish of Kahn wheels.

Stainless steel deep-dish wheels or wheels with diamond-turned rims require special care to keep these in pristine condition. Diamond polished wheels are subject to a different manufacturing process to conventional painted alloy wheels and are therefore far more susceptible to damage or corrosion from road debris, salt on the roads, and abrasive cleaning products. As such Diamond polished wheels and stainless steel deep dish alloys must be cleaned after every use and kept dry and clear of brake dust, road tar and salt.

Never use steam or hot water pressure washers for cleaning your alloy wheels. Using hot steam can cause damage to the clear coat laquer finish of the wheels and even dull the paint.

Likewise never clean Kahn wheels in direct sunlight which can dry the soap solution before it can be rinsed leaving residual water marks on the wheel.

Kahn Wheels should be cleaned at regular intervals appropriate to use, and should be done as often as required so as to ensure that corrosive brake dust, road tar and salt is not left to corrode the wheel, which can lead to pitting and blemishing of the finish.

If you are in any doubt as to the correct process for cleaning, advice can be sought from A Kahn Design Ltd by calling: +44 (0) 1274 749 999.

© 2013-2019 A. Kahn Design Ltd.
All rights reserved.
Any infringement of these rights will result in prosecution. Prices shown may exclude VAT unless stated. Local Currency prices are indicative only.

Investing in British Industry
German-British Chamber of Industry and Commerce

Kahn Design - The Road is My Catwalk

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Find out more here.

close x